hardMVS:

Adding a Pause Button to your MVS cab.
This is a very cool project that is pretty easy to do. Keep in mind, you will have to do a very small amount of soldering on your precious PCB, so if you are not comfortable with a soldering iron, you might want to find someone who is. I have to give credit where credit is due. I got the idea to do this project from JHendrix. He told me that he was going to do it to his supergun, and how to go about it. I added the idea of the disconnect and switch location, which I am very happy with as it does not require any drilling.
	You will need a soldering iron
	Solder
	20 Gauge hookup wire
	Wire strippers
	A Single Pole, Single Throw (SPST) switch or button. I used a Radio Shack p/n 275-324B. Make sure it is small enough to fit in the holes of your control panel if you don't want to do any drilling.
	2 wire molex connector male and female
	2 sets molex .093 pins for the above connector male and female
On to the project...

Adding a Pause Button to your MVS cab.